1mm Experience level: Beginner Print temp: ± 240 - 265° C Fan speed: 0-30%   Heat bed: ± 70 - 100° C Enclosure needed: Recommended

har god kemisk modstandsdygtighed

PVA-based glue sticks or additional adhesives

Det hindre støv i at trænge ind i din 3D printer

you should buy Monocure Rapid 3D resin

FLUX - H13 HEPA Filter Replacement - Beam Air Creality 3D - CR20/ CR20Pro - Reservedel 1mm Experience level: Beginner PrintH13 HEPA Filter for your Beam Air It is recommended that the H13 HEPA filter be replaced every 100 200 hours. Also remember to replace the other filters on time: See 3D Expert's selection of laser accessories here * Pre Filter (10 30 hours) * Medium efficiency filter (50 150 hours) * H13 HEPA filter (100 200 hours) * Charcoal filter (300 600 hours) Remove the filters: Open the filter top cover and remove the box from inside. Then take out the Pre